Warm reminder for Jiangmen ceiling fans: The climate has initially cooled down, and electric fans that have been used for a whole summer should also be cherished. Currently, there are many types of electric fans on the market. Apart from air conditioning fans, there are also ceiling fans, table fans, floor fans, etc. In fact, the sealing of electric fans is very different. The editor will introduce the sealing methods of traditional electric fans to everyone, hoping to be helpful to you.

According to the electrical fan circuit diagram, correctly disassemble the parts. When operating, first open the mesh cover clip, loosen the fastening bolts on the fan blade sleeve, and remove the fan blade; Unscrew the four screw caps that secure the rear mesh cover, remove the gasket and the rear mesh cover, and restore the nut gasket.

Take good care of the plated parts. First, use a soft cloth to clean the dust, stains, and water vapor on the plated parts, and then apply a thin layer of engine oil for protection. Please be careful, be sure to scrub and clean before oiling, otherwise the moisture will not evaporate easily after oiling, which may form corrosion dust spots and even cause rusting of the plated parts.

Take good care of painted parts. Wipe clean with a soft cloth, assuming that the stains on top are not easy to remove, you can use soap and water with less alkali content to scrub, or use a small amount of kerosene to wipe, then clean and dry. After disassembling the fan blades, wrap them in soft paper and place them between the front and rear mesh covers to avoid deformation of the fan blade angle.

Maintenance of other parts. The power cord should not touch harmful gases, such as mosquito coils, gas, etc., otherwise it will change the color and cause trouble. Motor bearings are oil containing copper bearings. To prevent oil loss, an appropriate amount of engine oil can be injected into the oil injection hole. The shake head knob is initially placed in the shake head position to avoid the compression spring being in a non tightening state.

In addition, before putting the fan head into a plastic bag and cardboard box, it is best to work without load for more than ten minutes, and stop packaging after the fan head is in good condition and cooled down. This can keep the motor in a dry state during winter.

If you have done all of these with your heart, the service life of your electric fan at home will definitely be greatly increased.

Article source: Jiangmen ceiling fan http://www.gd-dx.cn